Provided by: gnss-sdr_0.0.19-1build3_amd64 bug

NAME

       front-end-cal - RF front-end center frequency and sampling rate calibration tool.

SYNOPSIS

       front-end-cal -config_file=<path-to-configuration-file> [OPTION]...

DESCRIPTION

       front-end-cal  is  a  calibration  tool  for  some DVB-T receivers based on the Taiwan's Realtek RTL2832U
       chipset, sold in form of USB dongles that allow users to  watch  over-the-air  DVB-T  European  broadcast
       television on their personal computers, to be used as GNSS front-ends.

       Normally, those devices send partially-decoded MPEG transport frames over the USB, but exploiting an
       undocumented mode of operation of the demodulator chip, the user is able to obtain raw I&Q samples,
       stream them through USB to a personal computer and then use gnss-sdr, turning the DVB-T receiver into a
       GNSS receiver and delivering position in real-time.

       The crystal oscillator that ships with the RTL2832U family devices exhibits limited accuracy to be used
       as a GNSS receiver front-end without previous calibration. front-end-cal implements the algorithm
       proposed in [1], and it requires Internet access since it retrieves Assisted GPS data from SUPL servers.

       front-end-cal is able to work with raw data files or, if there is computational power enough, in real
       time with suitable radio frequency front-ends. The whole receiver is defined in a single configuration
       file, and therefore users can define theirs.

OPTIONS

       front-end-cal takes the following options:

       -config_file=<path-to-configuration-file> Set the configuration file.

       -signal_source=<path-to-raw-signal-file> If defined, path to the file containing the signal samples
       (overrides the data file specified in the configuration file).

       -log_dir=<path-to-directory> If defined, overrides the default directory where logs are saved.

       -version Print program version and exit.

       -help Print all the available commandline flags and exit.

SEE ALSO

       gnss-sdr(1),volk_gnsssdr_profile(1)

       Example of configuration file available at: ${prefix}/share/gnss-sdr/conf/front-end-cal.conf, where
       ${prefix}$ uses to be /usr or /usr/local. This will be the configuration file used by default if the
       -config_file option is not set.

       [1] C. Fernandez-Prades, J. Arribas, P. Closas, Turning a Television into a GNSS Receiver, in Proceedings
       of ION GNSS+, 15-16 September 2013, Nashville, Tennessee (USA). A draft copy is freely available at
       https://www.researchgate.net/publication/257137427_Turning_a_Television_into_a_GNSS_Receiver

       Check https://gnss-sdr.org for more information.

BUGS

       No known bugs.

AUTHOR

       Javier Arribas (javier.arribas@cttc.es)

       This software has been developed at CTTC (Centre Tecnologic de Telecomunicacions de Catalunya,
       https://www.cttc.cat) with contributions from around the world.

0.0.1                                              15 Dec 2014                                  front-end-cal(1)